If you have this problem, make sure you have the latest firmware on your printer. This was a problem in one of the early firmware releases and this problem is solved. When using non XYZPrinting filament, XYZWare says cartridge empty or not enough filament to complete the job In the mean time you can calibrate manualy (see bottom of this post). Try contacting XYZPrinting and ask for help there. If you tried all this and still get a fail, something else is wrong. Clean it with rubbing alcohol and try again. If less then four points are measured, the measuringpoint left of the nozzle is dirty, or the last meassured point is dirty. Repeat this in bigger increments until you get a result and hints on how to calibrate on the screen of the printer. If the result is still a FAIL, go counterclockwise 14 quarters and try again.
Turn the knobs clockwise 7 quarters and try again.
If the calibration returns fail, but all 4 points are measured, the bed is so much out of level, It can't do the right measurements. READ DOWN BELOW FOR NEW IMPROVEMENTS SINCE SOFTWARE VERSION 1.1.4.1 However, I found a solution for almost any problem now. Some of them really stupid, some of them really an issue for the people at XYZPrinting to work on. As I was one of the first owners of this printer, I found out a lot of things not mentioned in the manual of this printer.
0 kommentar(er)
